Conduit & Conduit Fittings
2", Two Hole Steel Strap, Snap On Type, Zinc Plated Steel, Use to Provide Easy Mounting To Support Rigid & IMC Conduit As Requried By The NEC Where Higher Load Bearing Supports Are Desired.
3/4" x 100', ENT Highly Flexible Tubing, Flex Plus Blue Smurf, Electrical Non-Metallic, For In Wall & Concrete Encasement & Power Conductors, UL & CSA Listed.
3/4", Screw In Coupling, Die Cast Zinc, For Use With Armored Cable/Flexible Metal Conduit, UPC Polybag.
1-1/4" Clamp Type Connectors, Twin Screw Die Cast Zinc, Use To Terminate Type NM Cable To A Knockout In A Dry Location Box Or Enclosure, Fits Service Entrance Cable: 10-2, 8-2, 6-2, 4-2 Non-Metallic Cable: 8-3, 6-3, 4-3, 2-3.
1/2" Service Entrance Elbow, Type SLB, Copper Free Die Cast Aluminum, Use To Provide Access To The Inside Of A Service Raceway For Wire Pulling Where The Racway Changes Direction.
3/4" Service Entrance Elbow, Type SLB, Copper Free Die Cast Aluminum, Use To Provide Access To The Inside Of A Service Raceway For Wire Pulling Where The Raceway Changes Direction.
1" Service Entrance Elbow, Type SLB, Copper Free Die Cast Aluminum, Use To Provide Access To The Inside Of A Service Raceway For Wire Pulling Where The Racway Changes Direction.
1", Compression Type Connector, For Use With Electrical Metallic Tubing, Concrete Tight, Die Cast Zinc, Use To Secure & Terminate Electrical Metallic Tubing To A Knockout In A Concrete Tight Box.
1-1/4", Compression Type Connector, For Use With Electrical Metallic Tubing, Concrete Tight, Die Cast Zinc, Use To Secure & Terminate Electrical Metallic Tubing To A Knockout In A Concrete Tight Box.
1/2", 90 Degree, Compression Type Connector, For Use With Electrical Metallic Tubing, Die Cast Zinc, Use To Terminate Electrical Metallic Tubing To An Unthreaded Knockout With A Right Angle Approach, UPC Poly Bag.
3/4", 90 Degree Compression Type Connector, For Use With Electrical Metallic Tubing, Die Cast Zinc, Use To Terminate Electrical Metallic Tubing To An Unthreaded Knockout With A Right Angle Approach, UPC Poly Bag.
1", Clamp Type Connector, Twin Screw, Die Cast Zinc, Use To Teminate Type Non Metallic Sheathed Cable To A Knockout In A Dry Location Box Or Enclosure, Fits Service Entrance Cable 6-3, 4-3, 4-2, 2-2, Non-Metallic Cable: 12-3, 12-4, 10-3, 10-4, 8-3, 8-2, 6-2, 4-2.
1-1/4" Water Tight Connector, For Service Entrance Cable, Flat Style 2 Insulating Conductors, 1 Bare, Die Cast Zinc, Use To Seal & Terminate Oval Type SE Or Type SEU Cable To A Threaded Entry Of A Watertight Enclosure. UL & SA Listed.
3 Pack, 1/2" Stamped Steel Drive Strap For Electrical Metallic Tubing Conduit, UPC Polybag.
3 Pack, 3/4" Stamped Steel Drive Strap, For Electrical Metallic Tubing Conduit, UPC Polybag.